Mobotix D24M-Sec Bedienungsanleitung PDF herunterladen (Seite 57)

57/148

D24M Camera Manual: INSTALLATION

www.mobotix.com • [email protected]

2.5.4 Procedure For D24M IT/Secure

1. Install and prepare the network connection

2. Install the ﬂush-mounted socket:The pre-installed cable attached to the camera

must be connected with the on-site network cable. For installation without acces-

sories, a ﬂush-mounted socket must be installed ﬁrst to provide space for the con-

nection. The cabling is now perfectly protected and cannot be seen or accessed

from the outside. The camera cannot be mounted directly on top of protruding,

surface-mounted sockets. Use the supplied camera drilling template (fold-out at

the end of this manual) to mark the position of the ﬂush-mounted socket for the

desired camera position.

Drill the holes: Drill the holes for the supplied screw anchors (see drilling template).

4. Connect the cable: Connect the on-site network cable to the camera patch cable

using a standard connector.

5. Attach the camera: Use the (included) screws to ax the mounting ring and the

camera at the designated position.

6. The outer shell is required at a later stage in the installation and is attached only

when the dome has been removed and placed back after a lens adjustment.

7. Proceed to Section 2.11, Aiming And Adjusting The Lens.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 147 148

Keine Kommentare

Mobotix D24M-Sec Bedienungsanleitung Seite 57