Mobotix MX-D25M-SEC-D76 Spezifikationen PDF herunterladen (Seite 113)

113/140

First Images and the Most Important Settings

www.mobotix.com • [email protected]

3.2.6 Starting the Camera with an Automatic IP Address (DHCP)

Under certain circumstances, you may have to reset the camera to its factory IP address.

This could be the case, for example, if the IP address has been lost or the camera does

not respond to the last known IP address. Proceed as follows to start up the camera with

its factory IP address:

1. If the camera is powered on, disconnect the power supply by unplugging the cor

responding cables and then reconnect the power supply.

2. Wait until both LEDs light up simultaneously for the ﬁrst time.

3. Press the R key within the next four seconds and hold it down (if you need to

try again, go back to Step 1). Use a suitable device to press a key (a ball-point pen,

for example).

After about 30 to 45 seconds, the camera emits a double sound (”boing boing”).

The camera has ﬁnished booting and can now be used (e.g., MxEasy, MxControlCenter,

MOBOTIX App, web browser).

Notes

Starting the camera with an automatic IP address (DHCP) is only temporary. The

network conﬁguration of the camera can be permanently set to DHCP under Admin

Menu> Ethernet Interface.

Make sure that the network has a functioning DHCP server when starting the camera

with DHCP support. If this is not the case, the camera cannot obtain a valid IP address

and will use its last IP address.

You should also make sure that the cameras always obtain the same IP addresses by

permanently assigning the MAC addresses of the cameras to the desired IP addresses.

In case of an error,

the camera uses its

last IP address

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 139 140

Keine Kommentare

Mobotix MX-D25M-SEC-D76 Spezifikationen Seite 113