Mobotix MX-D25M-SEC-D76 Spezifikationen Seite 91

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 140
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 90
91/140
Network and Power Connection
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
2.9.6 Connecting a USB Cable
Using the USB connector (red arrow in figure), you
can attach existing expansion modules, such as the
MOBOTIX ExtIO (USB), the MX-232-IO-Box or external
USB hard drives to the camera in a weatherproof and
well-protected manner.
Procedure
Uninstall camera: Remove the camera so you can access
the connectors on the back.
Remove the outer shell: Remove all four Allen screws using
the supplied Allen wrench. Take o the outer shell.
Remove the camera dome: Take the delivered plastic foil or
a cotton cloth and remove the dome by turning it in counter-
clockwise direction.
Tilt the main board: If required, release the two stainless
steel Allen screws and tilt the mainboard so you can access
the USB connector.
Remove the sealing plug: Push one of the three sealing
plugs out of the housing by pushing it from the inside.
Guide USB cable through wire plug: Gently push the angled
connector of the MOBOTIX USB cable (see
Section 1.4,
«Available Accessories»
) through the supplied black single-
wire plug (item 1.16).
Insert cable plug with USB cable: Push the wire plug with
the cable from the rear into the housing (make sure that the
plug is seated properly).
Connect USB cable: Push the MOBOTIX cable with the angled
MiniUSB plug into the USB connector (red arrow in figure).
You should use a USB
cable with an angled
MiniUSB plug inside the
housing of the D25M
Seitenansicht 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare