Mobotix T24 Technical Information PDF herunterladen (Seite 105)

105/118

Backup And Restore

www.mobotix.com • [email protected]

Notes

After installation and initial startup, the batteries of the Th24-DoormAster should be

charged continuously for the ﬁrst 12 hours. This takes place automatically via the PoE-

powered T24 door station using the MxBus two-wire cable.

During this time, the electrical door opening function should

not be used (except for functional testing). This will maximize

and extend the battery life of the high-quality NiMH batteries

(industry standard) to several years at normal use.

When a battery has been completely drained, a functional

test can only be carried out after the red LED has turned o

(after approx. 15 minutes).

When replacing the batteries, always be sure to use original batteries. You can purchase

these directly from MOBOTIX or your MOBOTIX partner.

5.2.3 Exchanging T24-Info Info Module

The door station remains operational despite the info module

malfunctioning or being exchanged. Because of this, you do

not need to run a system restore after exchanging it.

Proceed As Follows:

1. Disconnect the door station from the power supply (for example, remove the

network plug).

2. Remove the defective info module from the module frame as described in the

T24 System Manual Part 1/Section 2.4.6 (Removing And Exchanging Modules).

3. Exchange the info modules. Take care not to damage the cabling or mix up the

connections. The connection diagrams are provided in the T24 System Manual Part 1.

4. Power up the system again. After an automatic reboot, the door station is ready

for operation again.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 119 120

Keine Kommentare

Mobotix T24 Technical Information Seite 105