Mobotix D12 Technical Information PDF herunterladen (Seite 53)

2.8.4 Fixing the Camera to the Bottom Plate

In order to mount the camera to the bottom plate, use three of the supplied Allen

screws M4x25mm (item21), three washers dia. 4.3mm (item22) and the

corresponding hex nuts.

•Guide the connector cables of the camera from below (smooth side)

through the round opening of the bottom plate (item14).

• Position the camera on the underside of the bottom plate so that the PIR

sensor points in the desired direction and the hole in the casing to the right

of the PIR sensor is situated above a hole in the bottom plate.

• Insert the first M4 hex nut (item20) into the corresponding hole of the

bottom plate, then use one Allen screw M4x25mm (item21) and a washer

dia 4.3mm (item22) and

lightly

fasten the screw.

• Turn the bottom plate around and determine the number next to the hex nut

you just inserted (example: PIR points straight ahead hole should have the

number1). Insert the remaining M4

hex nuts (item20) into the other

holes with the same number (1 in this

case) and use the two Allen screws

M4x25mm (item21) with the

corresponding washers to fix the

camera to the bottom plate.

www.mobotix.com • [email protected] • 23.11.2006

51/96

D12 Camera Manual Part 1

Mount the camera casing

to the bottom plate

be-

fore

mounting the bottom

plate itself

PIR sensor of the camera

looks straight ahead:

Position 1

Caution

When fastening the Allen screws using the 3mm Allen wrench,

make sure that you do not scratch the camera dome!

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 99 100

Keine Kommentare

Mobotix D12 Technical Information Seite 53