Mobotix MX-KEYPAD1-EXT-SV Technical Information PDF herunterladen (Seite 108)

108/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

2.6.2 Mounting Instructions

Mounting Options

In addition to an on-wall installation using the supplied surface-mounted socket, you

can also choose to install the T24-Info2wire+ indoor unit using a standard in-wall socket

or a cavity socket (for wood or plasterboard, for example). Included in the delivery is a

cavity socket of very high quality with soft rubber gaskets on the rear that need to be

punctured by the two wires that feed in. The tight seal provided here is far superior to that

oered by standard cavity sockets without this feature.

Please follow the installation instructions in Section 2.5.3. They also apply to the

T24-Info2wire+ indoor unit.

Preparing And Testing The Two-Wire Cable

In general, Mx2wire+ is used with existing cables (bell wire). When cables have more than

two wires, make sure (color coding) that the same cable pair is used for both Mx2wire+

units (see ﬁgure). Approximately 5 mm of insulation must be stripped from both ends

of the two-wire cable.

Prior to installation, test the cable connection to ensure that it is functioning properly

(if necessary, draw up a test chart).

In-wall socket Cavity socketSurface-mounted socket

T24-Info2wire+

info module

T24-Info2wire+

indoor unit

\*/<$ -&+5

-&#$?$'; 2<$$7$2

P("# W$0&/<$ 1"#$2Q

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 149 150

Keine Kommentare

Mobotix MX-KEYPAD1-EXT-SV Technical Information Seite 108