Mobotix MX-KEYPAD1-EXT-SV Technical Information PDF herunterladen (Seite 138)

138/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

2.9.6 Connecting, Securing And Removing Modules

Connecting And Securing

For detailed installation instructions for Siedle products, see the documents provided by

Siedle directly.

1. Mount the Siedle installation frame: Position the

Siedle installation frame and snap it into place.

Ensure that the two-wire cable with the MxBus

push terminal is routed through and not jammed.

The MxBus cable must be secured to both of the

MxBus terminals on the terminal board (red wire

to +, blue wire to -). For more information, see the

circuit overview diagram in the last section.

The MxBus cable must be secured to both of the

MxBus terminals on the terminal board (red wire

to +, blue wire to a -). For more information, see

the circuit overview diagram in the last section.

Connect cable: Connect the camera patch cable

to the RJ45 connector on the terminal board.

Connect the MxBus push terminal with the camera

module.

Ensure that the camera patch cable is positioned

under the middle bar of the brass installation frame.

3. Mount the camera module: Place the camera

module onto the installation frame from above

and snap into place.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 149 150

Keine Kommentare

Mobotix MX-KEYPAD1-EXT-SV Technical Information Seite 138